PACKING: Resistors supplied on reels of 5,000 pieces per EIA RS-296-C
DIMENSIONS(mm.)
In
E. 530.5.....................
F. 6.6¡Ó0.5..................
P1.5.08¡Ó0.4...............
Pn.500¡Ó4..................
n:100 spacings
L. 6.35¡Ó0.25..............
2.090¡Ó.020
2.600¡Ó.020
200¡Ó.015
19.685¡Ó.157
250¡Ó.010
TEST
TEST METHOD
LIMITS
RESISTANCE
<0.005 ohm
OPERATING TEMPERATURE
-55¢J to +155¢J
MAX. CURRENT
5. amps
MAX. WORKING VOLTAGE
300Vdc
MAX. OVERLOAD VOLTAGE
600Vdc
TEMPERATURE COEFFICIENT
(PPM/¢J) 0 to - 100 PPM
SHORT TIME OVERLOAD
Apply 2.5 times the voltage rating for 5 sec
NO VISIBLE DAMAGE
LOAD LIFE
1,000 hrs. at 70¢J a direct voltage applied, cycles of 1.5 hrs. on
and 0.5 hrs. off throughout test
¡µ R = 0.5%
TEMPERATURE CYCLING
5 cycles of 30 min. duration at the extremes of temp range,
maximum and minimum, measurement of ohmic valure 4 hrs.
after completion of test
¡µ R = 0.5%
DIELECTRIC STRENGTH
Using a 90¢X"V" shaped conductive block apply 100V minimum,
Increasing 100V/sec. For 5 sec.
¡µ R = 0.5%
HUMIDITY
350 hrs. at 40¢J,90to 95% Rh
¡µ R = 0.5%
SOLDERABILITY
Dipped in Sn / Pb (60/40)at 235¢X,5sce. 1.5mm from the body
95% OF TESTED SURFACE
COVERED
VIBRATION
By Mil STD.202,201A
TERMINAL ROBUSTNESS
Traction, applied 2.5kg.for 10 sec. Bends,2 bends 90¢Japplying
Load to terminals of 0.5kg. Twist, 2 successive turns 180¢X, 6mm
From body
NO VISIBLE DAMAGE
RESISTANCE TO SOLVENTS
Trichlorethylene , TMC as the most aggressives for 60 sec. At
Boiling point.
NO VISIBLE DAMAGE
APPLICATIONS
Molded jumper wires or crossovers, as they are sometimes called, are basically interconnection devices between points on a PC board.
Generally they are used for the following reasons:
Inability to connect two points on a PC board due to other circuit paths which must be crossed over.
An after-the-fact design change that requires new point connections.
Circuit tuning by changing point connections.
Optional feature applications.
Quick Navigator Menu: (Right-Click again to close this menu.)
